Conrad parallel port radio clock

Synopsis

Address: 127.127.35.u
Reference ID: PCF
Driver ID: PCF
Parallel Port: /dev/pcfclocks/u or /dev/pcfclocku

Description

This driver supports the parallel port radio clock sold by Conrad Electronic under order numbers 967602 and 642002. This clock is put between a parallel port and your printer. It receives the legal German time, which is either CET or CEST, from the DCF77 transmitter and uses it to set its internal quartz clock. The DCF77 transmitter is located near to Frankfurt/Main and covers a radius of more than 1500 kilometers.

The pcfclock device driver is required in order to use this reference clock driver. Currently device drivers for Linux and FreeBSD are available.

This driver uses C library functions to convert the received timecode to UTC and thus requires that the local timezone be CET or CEST. If your server is not located in Central Europe you have to set the environment variable TZ to CET before starting ntpd.

Monitor Data

Each timecode is written to the clockstats file in the format YYYY MM DD HH MI SS.

Fudge Factors

time1 time

Specifies the time offset calibration factor, in seconds and fraction, with default 0.1725.

time2 time

Not used by this driver.

stratum number

Specifies the driver stratum, in decimal from 0 to 15, with default 0.

refid string

Specifies the driver reference identifier, an ASCII string from one to four characters, with default PCF.

flag1 0 | 1

Not used by this driver.

flag2 0 | 1

If set to 1, the radio clock's synchronisation status bit is ignored, ie the timecode is used without a check.

flag3 0 | 1

Not used by this driver.

flag4 0 | 1

Not used by this driver.